Average Reviews:
(More customer reviews)I had no problem installing it on my Droid Charge. The sizing was right and it fit perfectly to my device.
The steps I took to make sure that I wouldn't waste any of sheets were the following.
1) Find a clean surface to work in. Have a credit card or a smooth flexible plastic. Thoroughly wash your hands.
2) THOROUGHLY clean Droid Charge from fingerprints, smudges and small dust particles. I use packing tape to clean my phone. You can also use a clean lint-free fabric that you use to clean your eye-glasses or that came with your new LCD/Plasma screen.
3) Lay the unpeeled sheet over your Droid Charge to get the feel of the sizing. Be sure to check that the 2 cutout holes are removed. (top - earpiece; bottom - Home button)
4) The protector sheet is sandwiched between two outer sheets with one red label tape and the other a blue label tape.
5) The RED label tape should faced from the bottom side and the blue label tape - top side.
6) For best result; I started to peel the protector sheet from the bottom end of the Charge where the HOME button is located; peeling a ¼ of the sheet (both bottom and top sheets) and aligning the sheet WITHOUT touching the exposed bottom sheet.
7) Start using your plastic card to take out the bubbles working first from the bottom the edge of the phone; then reversed your motion and VERY SLOWLY peel the outer sheets (bottom and top) working toward the top of the Charge while Simultaneously using your plastic card to smooth out the protector sheet at the center of the glass.
8) After the protector sheet had been laid; if there are bubbles near at the edge, use the plastic card and smoothly push it toward the edge.
It took me less than ten minutes; the result is stunning. I cannot tell that there is a protector sheet from looking at the front of the Charge.
Click Here to see more reviews about: Cruzer Screen Protector with Cleaning Cloth for Samsung Droid Charge SCH-I510 - 1 Pack - Clear
No comments:
Post a Comment